FlyingGiants Forums - View Single Post

Stainless Skills · 11-01-2006, 11:32 PM

I always adjust my cg and incidence for that matter so I only have to push and pull a tad.

I always equal my trim out though, when I am upright I like to have to pull a little bit and push a little bit when inverted.

If you only have to push in inverted and not pull in upright then that screws up you nice axial rolls real bad.

Having the trim equaled out between upright and inverted is the only way!

11-01-2006, 11:32 PM	#4 (permalink)
Stainless Skills BOOMSHAKALAKA Join Date: Jul 2006 Age: 19 Posts: 801	Re: Elevator Trim I always adjust my cg and incidence for that matter so I only have to push and pull a tad. I always equal my trim out though, when I am upright I like to have to pull a little bit and push a little bit when inverted. If you only have to push in inverted and not pull in upright then that screws up you nice axial rolls real bad. Having the trim equaled out between upright and inverted is the only way!