Ok, I was out flyin about 2 months back, while it was around 45-50 deg F here in OH land, and botched an auto. Ended up in a blade strike, trashed the boom(obviously), broke a blade, bent the spindle, mangled the flybar. Check the main shaft, was ok, bought a new one JIC(just in case). Now, finally gettin it back together. Weather here has been really on the shotty side, for the polite version of it! I take it over to my buds place over the weekend, after I install a new 9254 tail servo. Fuel, and fire up. Hyper 50 was a little cantankerous on the first start, but runs AWESOME!! Hirobo Sceadu 50(non EVO), MS blades, V-Paddles, MAH tails, and I'm ready to fly circles!! Spool up and it startsto shake like no tomorrow!!!!
!!!!!!!!!! !!!! Check a few things, and try again.
!!!!!!!!!! !!!!! Then I get the bright idea to check the spindle. It checks good. Mast is fine. What is left to check?? PITCH of the blades!! Well, found a bit of a little problemo! Normal mode, low throttle low pitch, I have -4 deg each blade. COOL!!! I come up to where I read 0 deg pitch at 40% throttle, each blade. OK, cool!! 50% head on(looking straight at the canopy) left blade is +2, right blade is +2.75 approx. HMMMMM????? 75% throttle +9 and +12!!!!
!!!!! 100% power approx +11.5 to 12 and +16 PLUS!!!!!! Whats up with that!!!!!!!
Like I said before, Hirobo 50 Sceadu(non EVO), 8311's, 401/9254 combo, Hyper 50/MP2, MS blades, V Paddles, mah tails.........................
Not sure on what to do.........
HELP!!!!!!!!!!!!!!!
Bunky~