[NickThe]

just a quick note from Indonesia.

tested JR module on my old 40 size trainer,
1 flight on saturday, very slow response, I felt something is not right
The flight only lasted about 2 minutes.
So I decided to pack and went home.

that night I reroute the cable around the Rx and did JR modification as per XPS suggestion.
tested again on Sunday, very good, good connection. and I did 2 flights.
But I noticed that there is this "hole" that I got "hit" 2 times during my 2 flights.
other than that,............. Very Happy.

I also gave a Futaba module to my friend to be tested on Futaba 9C / 9Z
and here is his report :

Yesterday (saturday) I installed it in Futaba 9Z, do the binding and range check. The heli in Raptor 50 SE using 9252 servos, GY 401 & 9254 and Align 6A regulator connected with TP 730 mAh as a power source.

The binding went succesfully and so did the range check.

However, when I flew the heli I got several glitch (like temporary hit). Only to collective and rudder. I have tidyed the cable so none was touching the RX antenna. No other metal object near and touching the antenna.

and on sunday, he tried again :

Yes, all cables were more than 2 inches away from the antenna.
I range checked with the prog button pushed and get 100m distance with good result.

I am currious about the RX battery regulator.

Today I try again with different heli. Sceadu 50, 9252 servos, GY 401 & 9254 and 4.8V Nicd battry. Guess what? No glitching, none for 5 flight. Solid control all around. But the battery consumption is a little bit more than standard Futaba 149 DP. TX is change from 9Z to 9C Super.

Thanks and regards,
Ferri Iriandi

So Overall, we are quite happy, but of course with the additional antenna, I'm more confident to put it on my jets. but for now, I will just keep it only to my foamie or trainer...

Thx & Brg,
NICK - Indonesia