FlyingGiants Forums - View Single Post - Motor mount pics for .40 profile electric?

Simpleton · 02-12-2008, 05:16 PM

You can bolt a couple of pieces of like 1" aluminum angle to the sides, oriented vertically with the flange forward. Put them just far enough back to rear mount the motor where the drive washer comes out where it should, make them your "firewall". Strong, light, cheap, simple, doesn't look too bad if you dress the corners.

02-12-2008, 05:16 PM	#2 (permalink)
Simpleton That Was a Close Shave! Join Date: Oct 2006 Location: USA Posts: 548	Re: Motor mount pics for .40 profile electric? You can bolt a couple of pieces of like 1" aluminum angle to the sides, oriented vertically with the flange forward. Put them just far enough back to rear mount the motor where the drive washer comes out where it should, make them your "firewall". Strong, light, cheap, simple, doesn't look too bad if you dress the corners.