[Rod]

Once all the glue joints are done and the sheets are back flat on the table glue should squeeze out of the joins. Remove this carefully to avoid spreading the glue around as much as possible. I use a thin piece of plastic to scrape it up. Gently wipe as much glue off the joins with a paper towel. Leave for 15 minutes or so then sand the joints with fineish sand paper say 320 grit. The idea is to get sanding dust into the glue joint and fill any gaps. Leave for 45 minutes or so the turn over and remove the tape. Do the same again with the sand paper. Dont forget to mark the inside of the sheet. Cut the sheet in half on the diagonal and glue on the leading edge. Remember to cut one sheet on the diagonal one way and the other sheet on the diagonal the other way. Think about it. So you get 2 pairs with inside the right way round. Weight of 4 skins is 195gms bare and 202gms with dope