Seagull Ultimate 90 Bipe

[airboss/oc]

just got mine today, very nice kit ! been flying helis for too long so I decided to get a sweet Ultimate Bipe. it will be powered by an OS120 glo.
1) what servos do you recomend ? needs 6 digital and weight savings is important but not to sarifice power and speed.
2) power supplied by a Duralite 6v 7.5amp failsafe-on with 2s2500 lipo.
3) needs a CF landing gear, the alum version is heavy, who sell them ?
4) does anyone use 30% fuel in this engine ? I have lots of it for helis.
all info is appreciated.:198: :spy:

[olflyr]

I have had my Ultimate for 2mos. now and am thrilled with it. I powered it with an OS1.60FX and with that, it will almost pull the airframe out of the Ultracote. It does every manoeuver well except a knife-edge where it has a sizable pull towards the wheels. I used Hitec 5625 servos all around and changed the OE gear to SuperGear for the Goldberg 1.20 Ultimate. It looks good and works well.

[airboss/oc]

I was beginning to think this forum was washed up . thanks for the reply. where did you get the LG ? that is some insane power with the 1.60 what prop are you using ? flying 3D or pattern ?

[olflyr]

I got the gear from rcsupergear.com and after buying several different types of CF gear these are by far the best though not inexpensive. I use the Ultimate for 3D and have a Vess 18x8 prop on the 1.60. I have a 50cc gas 540 and 260 but find my cheap little SG Ultimate just a blast to fly.

[airboss/oc]

good info, I just ordered a new CF landing gear , but found one that fits better than the one you described and is also a supergear for the wildhare extra . what is your all up flying weight ?

[olflyr]

I just got around to weighing mine and it comes to 10.6lbs.

[airboss/oc]

thats kind of at the top end weight wise , I was shooting for 9.5 - 10. going to use as much CF in place of metal and screws will be aluminum.