2006 ETOC Sequence Post

[madmax]

Folks, these were just forwarded to me from Biff for posting. Aresti is currently being drafted. Hope this year's foam has a bunch-o-CF!

Enjoy,

MD - Biff



1) Ground take off, free turns but only one fly pass( excluding take
off) K1

2) Up right, Center box. Flat horizontal figure S turn with 1/2 rolls
opposite direction. Both out Exit upright K3.5

3) End Box. 1/4 roll to knife edge 180 degree knife edge turn, 1/4
roll to inverted. exit inverted. K2

4) Center box. 2 point roll follow by 1 negative snap roll. exit
inverted K4

5) End Box. push to vertical, 1/4 roll to 270 degree knife edge loop
back to center box. exit knife edge K2.5

6) Center box. From knife edge to torque roll. 2 turns left. climb
push to level. Exit upright Cross the box. K5

7) Center box. push to vertical. 1 full roll. push to level. exit
inverted Cross the box K2

8) Center box. From inverted. 1 Rolling circle. One roll out and
left. Exit inverted. cross the box K 4.5

9) Center box from inverted. 1 rolling circle. 1 roll out and right.
Exit inverted. cross box
K 4.5

10.) Center box from inverted. push to vertical. Horizontal knife
edge eight. push to upright. cross the box K3

11) center box. 2 of 4 roll. pull to vertical. 1 1/4 positive snap.
pull to level and upright. K3.5

12) End box from upright 180 degree rolling turn with 4 rolls out to
landing. Landing approach and touchdown it is judged as a part of
maneuver 12. K4

[excelpoint]

Bugger me, there's going to be foamies buzzin around like blue A$$ flys everywhere. Goto get out and try that.

[kim3D]

when is the time to register to the eTOC
and were is the place and what do i need to do to get in

[Biff]

Just so everyone is on the same page, this is 2006 sequence NOT the new (and way harder) 2007!! Kim there's a couple ways to get into the pilots list. We're nailing it down now. Of course it will be on the leading edge. Hold tight.

[kim3D]

ok thanks biff

[Breakstuff5050]

Sweet, they should make it way more complex though, get crazy with it

[randy archer]

any news on the Etoc 2007 seqeunce?
i can't wait, too excited lol.
ryan