Blender EXIT. what do you do?

[SleepyC]

Ok.. so I'm flying AFPD doing a few blenders... and I can't decide how I like to exit.

Whats the status quo, what do you guys do...

Lets hear it...

[Biff]

Pick up the parts that look re- useable.

[ShortBus]

	Quote: Originally Posted by Biff
	Pick up the parts that look re- useable.

LOL ^^^^^^


Rolling harrier exit

[green@3D]

	Quote: Originally Posted by Biff
	Pick up the parts that look re- useable.

same here lol


honestly i switch it up, reove rudder add power to hover, remove rudder add aileron, rolling harrier, just a smal dive out whatever

my fave is the too late exit though, gets the most reaction from the crowd

[Toro]

I will typically go to a rolling harrier circle with pauses on the knife edge.

[Rob B]

after a blender, i spend 10 minutes fighting my plane to the ground with a stripped aileron servo

[JClark]

Clean the ****e from my shorts.

[Neogenesis]

That all depnds on the plane I'm flying and how capable it as well as the pilot is that day. If it were my ucando .46 with a Saito 1.00 on the nose, the I would take it right from the inverted flat spin into a climbing inverted flat spin. Other thing I would do is take it from a inverted flat spin into a wing tip spin....bring it withing 10 to 15 feet of the deck, then go ballistic straight back up and do it again. On my ShowTime 4D, I like the flip it between inverted flat spin and upright flat spin. It's tougher than one would think to make it look smooth. If you don't get the sticks just right, it will do a ugly flop in the other spin. I was just getting good at it at the end of last season. Gassers....I usually just relax the sticks and fly out.....I try to keep it a little more tame with them.



Neo Out!!!

[3Dkid330]

I typically stop the spin and exit in an inverted harrier.

[damien]

	Quote: Originally Posted by 3Dkid330
	I typically stop the spin and exit in an inverted harrier.

Yeah me too, this way you can exit very low

[bodywerks]

	Quote: Originally Posted by Rob B
	after a blender, i spend 10 minutes fighting my plane to the ground with a stripped aileron servo

LOL! I dig your Avatar!!

[Huckin' it]

I just fall out into a rolling harrier or rolling cirlce