Infinite Menus, Copyright 2006, OpenCube Inc. All Rights Reserved.
Please support our sponsors
| | ||||||
| | ||||||
Please support our sponsors | ||||||
| | | | ||||
| | | ||||
| Welcome to The FlyingGiants Community! We're all about fun, and inside you'll find the greatest, friendliest, and most helpful group of people around! If this is your first time visiting, please check out site, and click here to sign up! We hope to see you soon!! |
| |||||||
| New to RC Modeling and Aerobatics? Wondering where to start? Find answers from our experienced crew! |
 |
| | Thread Tools | Display Modes |
10-30-2007, 02:51 PM
| #1 (permalink) |
| We Can Rebuild  |  Carbon or Wood Props Hi all just wondering what your opinions are on which type of prop you prefer or does it depend on what type of flying you are doing. And on a 50cc IMAC plane would you go 2-blade or 3-blade, My flying site is kind of noise sensitive. |
| <--Lame Post |  |
|
10-30-2007, 02:55 PM
| #2 (permalink) |
| Bad-ass Super Contributer!   |  Re: Carbon or Wood Props Carbon will be quieter
__________________ Cactus Aviation http://www.cactusaviation.com/ Fromeco http://www.fromeco.org/ Free Advice: Do Not Fly In Cow Pastures! Don't Clean your Engine With oven Cleaner! Check batteries after smoke is released from throttle servo! Don't put reeds in Backwards! |
| <--Lame Post | |
|
10-30-2007, 03:50 PM
| #4 (permalink) |
| Into The Light I Command Thee  | Re: Carbon or Wood Props Do you have a canister setup. Carbon will be quieter than wood. Three blade carbon will be even quieter at the exspense of engine performance.
__________________ To Fly or Not to Fly--That is the question....  FLYDawghouseRC.net Po Bro Member #1  |
| <--Lame Post | |
|
10-30-2007, 07:47 PM
| #5 (permalink) |
| Bad-ass Super Contributer!  | Re: Carbon or Wood Props Carbon 3 blade definately, unless you hit the ground. Last carbon I had struck in slow, level inverted flight. Bent the hell outta my crankshaft. Wish i had wood at the time but they are a little louder unless you go up an inch. |
| <--Lame Post | |
|
10-31-2007, 10:01 PM
| #7 (permalink) |
| Bad Mother Hucker!!!!!!!!  | Re: Carbon or Wood Props Carbon all the way. With 50cc range, there is basically no 3 blade compatible. 2 blade will do just fine.
__________________  http://www.freewebs.com/team_fearless/index.htm TEAM GOLDEN SKIES http://WWW.GOLDENSKIESRC.COM C.J.  What goes up must come Down!!!!!!  |
| <--Lame Post | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FlyingGiants Keyboard Deathmatch!! | madmax | The Clubhouse! | 282 | 11-22-2007 08:01 AM |
| Carbon Fiber or Wood prop? | caurimare | General Discussions - Giant Scale | 32 | 06-21-2007 08:30 AM |
| QUIET Wood Props | plane | Gas Engines and Power | 7 | 12-20-2006 03:57 PM |
| Redrilling wood props? | Eric H | Gas Engines and Power | 11 | 11-27-2006 01:03 PM |
| PT Model Carbon Fiber Props !!! | bryan01601 | What's Hot! | 23 | 09-08-2006 11:47 AM |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Re: Carbon or Wood Props 
Linear Mode
