Programming dual elevators in a 7202

[Berwyn Bill]

Hey all,

I've been switching planes from my old battered 8103 to a new 7202 and am having trouble getting the dual elevators set-up well. Could someone do a walk through of the dual elevator set-up in a 7202? Much obliged.

[mwoodman]

I have just been fighting with the same thing myself, and here is the solution, unless anyone knows a better way.

Go into the system list, and go to input select.
Inhibit Aux 2, and make Aux 2 trim active

Then, go into Prog Mixes, (I used 5 because it has trim feature linked from the master channel)
Set mix
ELEV ->AUX2 ON
RATE: +100%
+100%
SW:ON
OFFSET: 0

If your servos are mounted on the sides of the fuse, you will have to reverse either ELEV or AUX2 channel so they move the same way.

Hope that helps

Mark

[Berwyn Bill]

Thanks Mark. I figured it out a while ago. Just like you outlined, it works great.