Rudder 102" QQ YAK

[accaptain]

Setting up my pull pull. Do I need to bolt one ball link on the top and the other on the bottom of the carbon fiber rudder arm so that the pull pull cables don't rub each other? I am crossing them which is what I assume everyone else is doing.


Thanks,
Accaptain

[Vic3D]

Nope, just slide a nyrod or any other type of straw-like tube, antenna guiding tube will work too and tape it to one of the wires where they rub.

[Reza]

Yes. Nyrod does the job.

[accaptain]

	Quote: Originally Posted by Vic3D
	Nope, just slide a nyrod or any other type of straw-like tube, antenna guiding tube will work too and tape it to one of the wires where they rub.

I kind of already had my ends on prior to posting this. I did not put nyrod over one of the cables as the manual suggest because the cable appeared to have a plastic coating over it. Would this plastic coating withstand the rubbing together? Is there any mechanical difference in placing one ball link on the bottom side of the arm?

Thanks

[Hector]

	Quote: Originally Posted by accaptain
	I kind of already had my ends on prior to posting this. I did not put nyrod over one of the cables as the manual suggest because the cable appeared to have a plastic coating over it. Would this plastic coating withstand the rubbing together? Is there any mechanical difference in placing one ball link on the bottom side of the arm? Thanks

Mine have, and I fly it every weekend at least 5-6 times. But I didn't use the pull-pull that came with the airplane. I bought the Du-bro 4-40 one (They are almost identical).

I Fly it hard and haven't have any complaints. It Should work fine.

[Reza]

It should work fine!

[accaptain]

I will leave it as is. Thanks