9303 question

[Flyinrazrback]

is it possible to setup the throttle trim on the 9303 with one of the slider switches on the side of the tx? someone asked me and I am not sure, thanks!

[TonyThomasian]

Not sure though i have the same radio, but how can i set-up a high and low idle on a switch on the JR 9303???
Thanks

[Toro]

you already have one.... its the trim tab..... 1/2 is low, all the way up is high....

howz dat ?

[ibange]

I would set up a mix between the slider switch channel and the throttle and set it up for the range of movement you want out of it. Should work great if you set it up right.

[Flyinrazrback]

I know it already has a throttle trim, I thought it might be able to be changed to one of the side levers. To set an idle up, I use aux 4 to throttle, and in the DEV menu I set aux 4 to elev rate switch and set the percentage on the aux 4 to thro mix if that makes sense.

[budgetdude]

Tony, mix a throttle to throttle mix and assign it to a switch like your aux 2 switch then bump up the percentage. I also put my idle/down elevator mix on the same switch.

[Dennis C]

A slider can't be directly used in place of the throttle trim, however you can set up a program mix to make the slider adjust the throttle channel. To do so, mix either LLVR or RLVR to throttle and set the rates as desired.

I hope this helps

[hillmanr2]

You can do it. But be very careful how you do it. I experimented on the Sim with this using the left slider. In the end it seemed better to use the throttle curve but this was only for my situation.