Will a Futaba 7C Computer Radio Air R617FS S3152 Servo 2.4GHz work ok will the Ar9100 Powersafe rx? Also can someone recommend good batteries to install? I need 3

Alright, as yall know christmas is almost here and I'm broke! I have a specktrum dx6i and I do not trust it in my gas planes! I just feel the radio and reciever is built cheaply and I'm going to buy a jr9303 after the holidays. At any rate, until than i got to make due with what I have. I have flown the plane twice with the ar6200, y-harness with a built in servo reverser on the elevators (big no no), dual batteries plugged right into the reciever which leaves me fresh out of channels. My question for you experts: Is it possible/safe for me to run TWO ar6200 recievers in the plane that way i can...

Hi, is there any one that knows there Futaba CHP9 really well, i need a step by step explanation of the simplest way of setting up Peak model Yak 54, 85 inch, DLE 55, Futaba 9CHP, 2 seperate ailerons, 2 seperate Elevators, throttle, kill switch (servo type)Rudder (1 servo), and choke, all hitec digital sevos, not keen on using Y leed for elevators. any help would be great.

what percent throws would you guys use for 3d flying on a 35% yak. is it possible to have too much throw for 3d flying? thanks

my brother has a new yak with a dle 111. engine will surge at idle and shut off or it will not surge but just shut off. we have ran tubes from the carb to inside of fuse. we have tuned it everyway possible. we have put two gallons of gas through it on the ground. any idea on what is causing this problem???? thanks