MAJOR 2.4 Ghz Spread Spectrum Release! A FlyingGiants Exclusive!

[spektrumrc]

	Quote: Originally Posted by rob10000
	I'd like the Spectrum reps to comment on the apparent editing of the pictures of the 12/14MZ module. I'd accept that these pictures are of a protoype that didn't make the final cut. However, Horizon is accepting pre-orders for a stated late April delievery. Is that module going to have a 2nd cord like the pictures suggest, or have they eliminated it?

The MZ module does have a connection to the DSC interface. We have been trying to eliminate it but have not been sucessful so far.

Paul

[catman3070]

	Quote: Originally Posted by spektrumrc
	The MZ module does have a connection to the DSC interface. We have been trying to eliminate it but have not been sucessful so far. Paul

If you read my previous post it explains why it can't be eliminated.

Frequency change must be done internally by Futaba service center.

[wings19]

Regarding the AR6100 receiver... Would it work in my 47" Extreme Flight electric Yak? It's not quite a foamy or park flyer. I think the constraint is range?

[OverTemp]

Hey Folks,

Any word on whether or not you can use 1x7000 and 1x9000 at the same time, or do they both have to be the same type of RX?

Thanks

[spektrumrc]

	Quote: Originally Posted by wings19
	Regarding the AR6100 receiver... Would it work in my 47" Extreme Flight electric Yak? It's not quite a foamy or park flyer. I think the constraint is range?

I would use the AR7000 in this application. It's not a question of range but multipath reflections from the internal componenets such as the motor and battery.

The dual receiver in the AR7000 will always be able to resolve them..
Paul

[spektrumrc]

	Quote: Originally Posted by OverTemp
	Hey Folks, Any word on whether or not you can use 1x7000 and 1x9000 at the same time, or do they both have to be the same type of RX? Thanks

They both have to be the same.

Paul

[Bunky F. Knuckle]

I have a question about the binding proces......... How do you go about it??

I'm familiar with the DX 6 and the AR 6000................

[rk22]

	Quote: Originally Posted by spektrumrc
	They both have to be the same. Paul

Will this DSM2 Spektrum modules for Futaba Tx work also with older transmitters such as Futaba FC-28? That Tx is using FP-TQ-FM module.

[OverTemp]

	Quote:
	Quote: Originally Posted by OverTemp Hey Folks, Any word on whether or not you can use 1x7000 and 1x9000 at the same time, or do they both have to be the same type of RX? Thanks They both have to be the same. Paul <--lame post

Bummer. First bad thing I've found about this stuff.

[ermohn]

Will the SST modules available for the 72mHz radios work with the 35mHz radios we use in Europe?

Erik Reed Mohn

[yoyosmuggler]

The long servo leads on a giant scale can act as a receiver. I have an i4c isolator in my 33% to prevent these gliches. Does the spektrum system eliminate the need for servo isolation?

[OverTemp]

yes