Extreme Flight Chinn Yak 55sp

[jwmachon]

I did reveive it originally bug completely trashed the back end, so i need to build a new tail section

[flygilmore]

Then.....why did you claim you did not recieve "them" with the model??? Or....are you talking about the measurements? No measurements/plans are going to come with this ARF-are the pieces so bad that you cannot "piece" them back and get a rough idea of where to begin constructing new tail feathers?

[livinma1]

Hey Guys -

I picked one up from a fella on rcuniverse and he originally had a Saito 82 in it. I am going to put my ys 63 in it but trying to figure out the best way to mount it. Any pics of how you guys got it mounted. I mocked mounted it and the servo arm is well under so I will have to do a very big bend to get the servo arm to the lever for the throttle.

[Matchless]

How does this do for ya?

Throttle servo pushrod exits some antenna tube poking out of the lower portion of the wing.

[livinma1]

	Quote: Originally Posted by Matchless
	How does this do for ya? Throttle servo pushrod exits some antenna tube poking out of the lower portion of the wing.

Thanks for the pics Matchless, I will take a pic in a moment to show you what I am dealing with. Can I see a pic of the actually throttle arm linkage setup if possible.

I think I may have to rebuild some of the area he dremeled out.

[livinma1]

Here are some pics of the nose of my yak. The fella that originally had it had a saito 82 on it and he had to dremel out the area to fit it. Now it seems like I have to rebuild that area in order to get my ys 63 to fit.

What are your recommendations ?

[rcflyer]

Be careful of the upthrust/downthrust angle. You could use blind nuts to secure the engine bolts to the mount

[livinma1]

	Quote: Originally Posted by rcflyer
	Be careful of the upthrust/downthrust angle. You could use blind nuts to secure the engine bolts to the mount

Hey Rcflyer -- Thanks for the reply. If you look at the last pic you will see that I have no wood to grab with the bolt. for the top section and also for the bottom.

[Chinny Chinn 55sp]

Hey just got my New chinn yak 55 Im putting a saito 82 on this one with a 14x4w prop on it I was wondering what 4 stroke nitro % to use with this settup? Im also adding smoke!

[Flatlandman]

30% nitro heli mix

[cjcyclesrc]

It will smoke pretty good with the 30% heli fuel. I wouldn't suggest you add any other smoke systems to the plane. You want to keep the weight down as low as you can.

[Chin Yak Master]

Just completed my New Chin Yak sp. The plane is sweet! Im gonna Maiden her tomorrow! The saito 82 has monster power on a plane of this size and wieght! I put a micro pump and centered a small smoke tank that I made through the fusalage. This is the first time I added smoke to my Chin. I't put me right on my C.G at 5 3/8 inch! I'll let you know how it went and ill have some Vidio tomorrow! 14/4 prop,7.4 volt 2500 mah pack,saito 82, HTec HS 7965MG Coreless Digitals all around and Htec speddy servo on the throttle,micro smoke pump and 4.8 once custom Titanium tank for the smoke! Happy Flying!