3" Spinner needed!!

[Royster]

Now I know why I buy overseas. I cant seem to find anyone in Brisbane who stocks a metal 3" spinner!

Even Precsion Aerobatics are are out of stock!

I can get one from the US but will have to wait a few weeks and need it before then.

Howie at DA has em but they are for DA engines and not for my SPE40

Can anyone help?

[exeter_acres]

3" isn't too big... Have no clue about Hobby shops there... but doesn't anyone carry a 3" Tru Turn?

[BIG STEVE]

What is the hole to big in DA one

[Royster]

	Quote: Originally Posted by BIG STEVE
	What is the hole to big in DA one

Dont know? I fact I didnt even bother to compare as I figured it was for a DA so no way was it going to fit.

I might take up the prop bolt to DA and see if it comes close

Otherwise I may just have to get on the forums of owners of the SPE40 and see what they use.

Found a 3" spinner in NSW but I think it will need some major moding

[ULTIMATE1]

CHECK OUT EBAY THERE IS ALWAYS ALUMINUM SPINNERS LISTED NEW IN BOX I HAVE ONE

[Royster]

	Quote: Originally Posted by ULTIMATE1
	CHECK OUT EBAY THERE IS ALWAYS ALUMINUM SPINNERS LISTED NEW IN BOX I HAVE ONE

eBay, Tower Hobbies etc. Yeah I know dude, but I need one sooner than 2-3 weeks.

After all cant maiden the plane without a nice chrome spinner, its a sin!

[DesertHucker]

How does your prop bolt on.
6 bolts?
or
1 bolt in the centre?

If it is 6 bolts than any tru turn should fit.
if it is a single bolt than you would need an adaptor.

Otherwise a PA carbon one would fit with no adaptor.

Or any spinner that does not use a centre bolt.
The ones with the little screws arround the back plate

[Royster]

All solved guys!

I just bought 3" True Turn from Desert Aircraft and just have to drill two additional holes on the back plate and I'm done!

Just need to find someone with a drill press.



Mmmm those DA engines sure look nice