Infinite Menus, Copyright 2006, OpenCube Inc. All Rights Reserved.
Please support our sponsors
| | ||||||
| | ||||||
Please support our sponsors | ||||||
| | | | ||||
| | | ||||
| Welcome to The FlyingGiants Community! We're all about fun, and inside you'll find the greatest, friendliest, and most helpful group of people around! If this is your first time visiting, please check out site, and click here to sign up! We hope to see you soon!! |
| |||||||
| Electronics, Gyros & Gov's Servos, gyros, gov's and all elecrtonic components |
 |
| | Thread Tools | Display Modes |
03-18-2008, 02:15 PM
| #3 (permalink) |
| In debt up to my eyeballs..!!!   |  Re: G401y ? GY401 gyro on the airplane rudder.... why...??? Scott
__________________ "Because it is the right we turn to when all else fails. That's why the Second Amendment is America's first freedom..." Charlton Heston 1997 |
| <--Lame Post |  |
|
03-18-2008, 05:12 PM
| #5 (permalink) |
| NCFR Rocks (even from here!)  | Re: G401y ? no need for a mix... at least never was for me,,, just set gain on its own channel.... are you increasing gain as you increase rudder or something like that??
__________________ I set a World Record at SEFF!! Try not to let your mind wander...It is too small and fragile to be out by itself. http://www.atlantahobby.com/ http://www.mercuryadhesives.com/ http://www.extremflightrc.com |
| <--Lame Post | |
|
03-18-2008, 07:08 PM
| #6 (permalink) |
| Gohbee Dude  | Re: G401y ? I have a rudder to gain mix on a switch. I have an inverted V curve so that as I increase rudder input the gain goes down. So at full rudder the gyro is effectively turned off. The only time I actually use this is for a ripper where I want the absolute maximum possible pirouette rate. |
| <--Lame Post | |
|
03-19-2008, 12:14 PM
| #8 (permalink) |
| Gohbee Dude | Re: G401y ? It works for a Ripper. It is bad news for any other flying. WARNING!!!! Make sure that your battery and other electronics as well as mechanical parts, are well mounted or they will leave the heli at the max mechanical piro rate. I have had the centrifugal force pull off the tail boom on a shaft drive tail at this piro speed. Last edited by Flyinfool : 03-19-2008 at 12:17 PM. Reason: More info |
| <--Lame Post | |
|
03-20-2008, 06:28 AM
| #12 (permalink) | ||||||||||||||||||
| Multi Platform Pilot  | Re: G401y ?
Nice Jeff, very nice! Is there video of that anywhere? I suppose on the good side, you dont have to worry about a boom strike! 
__________________ Andy AMA 77227 http://www.jaxrc.com Florida Freestyle Aerobatics Association LETS GO FLYERS! | ||||||||||||||||||
| <--Lame Post | | ||||||||||||||||||
Linear Mode
