Cant program my Heli eCCPM 14MZ

[Kiwi]

Man I'm about to jump on this thing.

Here's my problem. I have a Dragonus 450 sized heli and I'm doing the tuning on it. I have the head off so if it cranks up it wont bite but I'm buggered if I can get two things to work right.

1. My elevator is reversed. Of I pull back and the swash rolls forward, all the pitch and aileron work perfect. So I reverse the elevator servo and now my aileron control is reversed. I go to the hardware reverse screen and reverse the stick, it stays the same. Dang man I can program a plank in ten minutes with conditions and all the bells and whistles but this heli has me bummed out totally.
2. Off course the darn pitch is in reverse as well, up is down and down is up. Reverse all the servos and my cyclic is trashed again. Plush the numbers on the screen are showing with zero throttle 100% and full at 0%. Gawd durn it I'm brain dead on this one.

Help anyone. Does anyone have a Dragonus on a 14MZ so they canshare me the Mdl file to start with.

UGGGGHHHHHH I love these little heli's and there here to stay but I need to get over this bleedin programming issue.

[Mudsurfer1234]

If your elevator is reversed, do NOT reverse the servo..

There should be a setting in there called "Swash AFR" or something like that, that will have "Pitch" "Elevator" and "Aileron" values, followed by percentages. By default they should be like all +50%. if the ELEVATOR is reversed, then change the elevator value to -50%.

If the pitch is backwards, change the "Pitch" value to -50%.

If it's not too much trouble, could you post a pic of the screen on the radio? i'm not sure quite how the MZ shows these, but i'm going off of my 9C.