37% Ultimates

[krayzc]

i 2 saw 6500 reports i did 5800-5900 27A of memory on mine in the back yard. I did 6020 or so on a 28 x 10 Mejzlik. I did not fly either one just wanted to know what RPM mind would pull. I did 6750 that same evening on the 26A.

[Grandpa]

This is an outstanding airplane once dialed in, I have finally found the engine for mine (my BME let me down), I have a Kroma 100I in mine and it works great . Motor still breaking in 6300 on a Xoar 27x10 rich.

[krayzc]

grandpa what all dialing in hard u had a chance to take care of?

[Grandpa]

Just the nomal pitch and roll coupling stuff, and engine thrust angle (up).
nothing hard. And this plane will really fly slow too.

[krayzc]

grandpa i 2 love to have that part of the puzzle behind me on a model to

[UAVPILOT_JOE]

What about a ZDZ Super 80? I have it on a CompARF 260 2.6m right now, but might be looking to get another plane for IMAC. It hangs the 260 nicely at 3/4 throttle.
The Ultimate looks great.

Joe

[dbcaster]

The plane flys great with my DA-85. I think a ZDZ-80 would be good also.

[UAVPILOT_JOE]

Super.... I might Have to get one
Joseph Millette

[Grandpa]

I flew mine with a sick BME 100 that is still missing (at BME I hope they will not answer emails). Anyway it made about 1/2 powert and still flew the plane well. Just move everything forward and you should balance ok and the 80 single will be more than enough power. I have a Kroma100 in it now and it's a LOT of fun to fly now Lotsa of power.

[jdearduff]

I am putting one of these together right now, and I am wondering if there is anyway to get an updated manuel for it. The old BME manuel is only for about 70% of this plane. I can figure it out but a new manuel would be nice for future planes. Also get ride of those vinyl graphics. Get something new. Put in a PAU decal.

[claselva31]

I'm just about done with mine. The manual is the old version but it's accurate to the new one except a couple of points. The wing tubes & horizontal tubes.If you have any ?'s I'll help any way I can. If you go to RCU there is a lenghtly forum on this build. Chris

[jdearduff]

	Quote: Originally Posted by claselva31
	I'm just about done with mine. The manual is the old version but it's accurate to the new one except a couple of points. The wing tubes & horizontal tubes.If you have any ?'s I'll help any way I can. If you go to RCU there is a lenghtly forum on this build. Chris

I am not having any problems putting it together. I just think it is a great plane and a really nice manual would top off the kit.