how to change switch on/off with 12z

[steve90210]

Hello,
Does anyone know how to change the switch on/off assignment on a switch. Right now it's:
on
off
off

How do I change it to:
off
on
off

I had thought I changed it in the function menu after you select what switch to assign that function to. I don't know if something changed during the updates or I just forgot how to do it.

Thanks for the help.

[Altavillan]

Go back through the setup, when switch choice is made a new page pops up and you set the switch there.

[Rolling Thunder]

You have to highlight the OFF that you want to change, then push and hold the button until it beeps. Then you have to change the original ON postion the same way.

[prizzy]

Like rolling said. High light the off, roll the wheel until it shows on, then press enter to confirm. You do this on all three, or any you want to change.

[bax]

Actually, you'd do this in the AFR menu. Go to the AFR menu and select the function that the switch controls. Set it to "LINE". Now eliminate all but the end and center points. Set the center point to +100%. Set both end points to -100%. This gives you a 3-point "V" curve. If it's the wrong way, then change the "+100%" to "-100%", and the "-100%" to "+100%". This will set up the switch to work the way you want it to.

[steve90210]

Bill, thanks for posting the solution here too. I just saw you posted in the flyers club also. Since the updates I can't get to the menu after you select which switch. So I will have to use the AFR menu now.

I wish they would bring back the other menu.

Thanks
For all the response's