Infinite Menus, Copyright 2006, OpenCube Inc. All Rights Reserved.
Please support our sponsors
| | ||||||
| | ||||||
Please support our sponsors | ||||||
| | | | ||||
| | | ||||
| Welcome to The FlyingGiants Community! We're all about fun, and inside you'll find the greatest, friendliest, and most helpful group of people around! If this is your first time visiting, please check out site, and click here to sign up! We hope to see you soon!! |
| |||||||
| New to RC Modeling and Aerobatics? Wondering where to start? Find answers from our experienced crew! |
 |
| | Thread Tools | Display Modes |
04-02-2008, 01:16 PM
| #1 (permalink) |
| Gettin' Lower!   |  Confueses with linkages I have to put wire from a servo in side and goes through fuzz and to the elevator. There's a bag with bits in and I'm unshore how to clap the cables. there's the cable and cleves arrangement, with 4 small and big er copper tubes. I no you clamp the tubes to grip cables and i would glue them as well. can any one unconfused me please. The aeroplane is Extra 260 25 %  |
| <--Lame Post |  |
|
04-02-2008, 02:14 PM
| #2 (permalink) |
| Hard Man   |  Re: Confueses with linkages Are they solder couplers perhaps?
__________________ www.ohiomodelplanes.com |
| <--Lame Post | |
|
04-02-2008, 02:37 PM
| #3 (permalink) |
| Will fly for food.  | Re: Confueses with linkages Thread a crimp (brass tube) on the wire, run the wire through your control horn hole or through your clevis adapter (threaded bit with a hole in the end), run the wire back throught the crimp, brign the wire back around and through the crimp again. pull out 99% of the slac (leave a little loop, in other words, don't kink the wire), take a set of small vice grip pliers and crush the tube that now has three passes of cable inside it. You are done. Check out post #16 of this thread on RC Universe. It will help you figure out what I'm talking about. http://www.rcuniverse.com/forum/m_34...tm.htm#3489786 Jon
__________________ Jonathan Ott CPT, LG, USAR Lewes, DE AMA 107225 IMAC 2741  |
| <--Lame Post | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Composite Arf and Recommended Linkages? | bob_nj | Giant Scale Airframes and Kits | 13 | 11-28-2007 12:53 PM |
| Contol Horn Linkages | iflyrc3Dstyle | General Discussions - Giant Scale | 2 | 09-20-2007 10:32 AM |
| Best Control Linkages | F3AFlyer7 | Building, Repair, and The Details - Tips and Tricks | 10 | 03-15-2006 05:52 PM |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
