E-flite's EDGE 540 BP 3D ARF

[sl1200mk2]

Good job!

Horizon has been out of that motor for a couple weeks now. Both my LHS were out too, so I had to drive about an hour south to pick one up from another shop. Awesome little motor though... I can see why they are so popular.

Everyone at the field really likes the plane -- it's a great flyer. I need to work on a mix for knife edge, but that's it. Hardly any wing rock either inverted or upright and once you get a good CG point it just floats around.

Let us know once you get it together!

- Wayne

[wcc963]

	Quote:
	Good job! Horizon has been out of that motor for a couple weeks now. Both my LHS were out too, so I had to drive about an hour south to pick one up from another shop. Awesome little motor though... I can see why they are so popular. Everyone at the field really likes the plane -- it's a great flyer. I need to work on a mix for knife edge, but that's it. Hardly any wing rock either inverted or upright and once you get a good CG point it just floats around. Let us know once you get it together! - Wayne

yea i will definetly post when i get it and get it together. my LHS was out to, but the happen to have one on oreder to be here by tuesday, and the plane should be here wensday. so that will work out perfectly.

[wcc963]

instead of the park 450 im gonna go with the Rimfire 28-30-950 motor instead, wat do you guys think?

[MrKiwi]

That motor should work fine.

[wcc963]

	Quote:
	That motor should work fine.

now will it be less powerful, as powerful or more powerful than the park 450?

[wcc963]

well i got it today and tis together, but i have one issue, this is the first airplane ive done with a seperate servo for each aileron. how do you get them to work together without a Y-Harness? is there a mix i could do.

im using a DX7, AR6100, and HS-55's.