mini funtana help please

[ultimate]

Hi friends this is my first post in the forum, Hello to all Mini-Funtana owners. My set ut is an Axi 2808-24, Electry-Fly 30 Amp. ESC, Apc slow-Fly 11 X 4 prop, and 1S3P 1800 lipo batery, Hitec electron 6 recv. and 56 Hb. servos.
For me the performance is outstanding, and have enough power to hover, torque roll and bail out just in case. Before I used an 10 x 6 prop, but the speed was very fast, ( good for Aresti, not so for 3D ).
The mounting for the engine is carbon fiber arrow shaft, with aluminium inside so the screw can rotate better,and keeping the same angle trusth.

[ultimate]

Here is the photo.

[ultimate]

[quote=ultimate] and other

[ultimate]

in the will blue.

[3dcrazy]

man sleepy if you could find that site where you have ordered stick mounts for out runner motors would nbe awsome!

[Flatlandman]

heres one

www.3dfoamy.com

http://3dfoamy.com/catalog/product_i...products_id=86

[ShortBus]

for added support on these axi's you can cut a PVC pipe tot he correct length and use it as a "firewall" with the screws going back but tightening against the PVC pipe