Hanger 9 funtana s40

[3D-flyer-93]

Is the hanger 9 funtana s40 a good flying plane for a intermediate pilot that owns/flys 3D planes? And this will be my first nitro plane to.

http://www.redrockethobbies.com/product_p/han1975.htm

[casey g]

well sort of its ok i have one and i really dont like flying it
its a all out 3d plane no pershin(spelling) but it does 3d good it has a lot of coupling iin knife edge i have my cg way back and it has a hard time hulding the nose up in knife edge.
i have a saito 100 on mine and it rocks
jr ds811 servoes all around

i have not flown this plane yet but i think its going to be my next its the fliton edge 540 freestyle gmilo really flys it good and i want a plane that can fly a strait line lol
and be smooth
here is the link then go down to the edge or extra i want the edge http://fliton.com/new/doc/frame.asp
there u go

[MrKiwi]

Its a good plane for 3d, but horrible kinfe edge though. And be very carefull with the wing, th ribs are paper thin. Here's a picture of mine.

[casey g]

i riped the right elivater half off all that held it on was the little bar
was a wide open blender with the satio 100 on it
was a awsome blender lol and i wwas able to land safely

[3D-flyer-93]

its comes with a O.S sf .46, and a JR quotro radio, flight sim, sim cable, RX, JR RX battery, TX battery, charger, prop, spinner, all servos installed, fuel lines, fuel tank, the plane (DUH), landing gear, wheels, wheel pants, and everything is pre-installed. And what else to I need to get it in the air?

[3D-flyer-93]

its comes with a O.S sf .46, and a JR quotro radio, flight sim, sim cable, RX, JR RX battery, TX battery, charger, prop, spinner, all servos installed, fuel lines, fuel tank, the plane (DUH), landing gear, wheels, wheel pants, and everything is pre-installed. And what else to I need to get it in the air?