ATTN G3 FLYERS!FG HUCKFEST SESSION!

[Mudsurfer1234]

Hey guys, i just found out yesterday, that i can host sessions now. (got a new router, my old one didn't let me host)

So, every weekday, starting at around 3:30 eastern, i will be hosting the "Flying Giants G3 Huckfest" session, untill 11 pm.

There's 15 slots, so come on in and hang with your fellow FG G3'ers!

[Mudsurfer1234]

Also, don't forget to suit up your Yak with the Flying Giants colorscheme!

This is a really nice scheme from WingsWest328.

http://www.knifeedge.com/forums/down...=1894&act=down

[Edge 540]

There are two G3 flyinggiants fields open. I cant connect to either one. It's not a problem on my end because I can go into any of the other sessions.

[ilovemetro]

lol thats weird cause my session is flying giants 3d huckfest, i had it open but its closed now, had to send someone some pictures to get a new g3 model!

[dpoles]

i can't get on to the session. I can get onto other sessions full of idiots, but not this one

[Mudsurfer1234]

I have it up now, i am not quite sure what the "Optional Port Number" box should be....

When i leave it blank, it says "IP Address found XX.XX.XXX.XXX:13257"

so i put "13257" in the port number box...

Should i be leaving it blank?

[matt3D]

Yo what up mud surfer? remember me? Don't worry about the port numbers, just leave em blank. Make sure you have upnp enabled and port foward 2302 udp and 6073 tcp for g3.5. If you need help with it let me know. We can use windows remote assistance, so I can help ya.

Regards,
Matt