FlyingGiants - View Single Post

flight_stick · 01-04-2007, 01:07 PM

Guys,
Have started putting together a very nice Aeroworks 39% Edge. The RTC kit. Have a small, problem with the wing joiner. They suggest just a machine screw through a hard point into the wing tube, from the underside one on each side. Not too sure if I am happy with this. Would like to do something like blind nuts, two on each wing and screw in from inside off fuzz. Any suggestions. Wing in foam core with ply on root.

Gary

Promise to post pics of progress

01-04-2007, 01:07 PM	#1
flight_stick Bad-ASS Pit Mechanic Join Date: Dec 2006 Location: Mother City, South Africa Posts: 1,245	Need Help with 39% Edge Guys, Have started putting together a very nice Aeroworks 39% Edge. The RTC kit. Have a small, problem with the wing joiner. They suggest just a machine screw through a hard point into the wing tube, from the underside one on each side. Not too sure if I am happy with this. Would like to do something like blind nuts, two on each wing and screw in from inside off fuzz. Any suggestions. Wing in foam core with ply on root. Gary Promise to post pics of progress