FlyingGiants - View Single Post - Smart-Fly power expander on 2.4??

Rolling Thunder · 01-16-2007, 05:04 PM

I am setting one up for Smartfly right now. The one thing I ran into was to set the failsafe. The DX 7 failsafe is set by binding the unit after all the controls have been set, especially throttle.

To bind the unit you have to use there switch into the battery port on the rx. So I disconnected the rx from the Power Expander and plugged in the JR switch like the manual shows. Then I plugged the rx back into the power expander and all is working fine and the failsafe is set.

01-16-2007, 05:04 PM	#2
Rolling Thunder Tony Quist Join Date: Jan 2006 Location: Glendale, AZ Age: 48 Posts: 1,492	Re: Smart-Fly power expander on 2.4?? I am setting one up for Smartfly right now. The one thing I ran into was to set the failsafe. The DX 7 failsafe is set by binding the unit after all the controls have been set, especially throttle. To bind the unit you have to use there switch into the battery port on the rx. So I disconnected the rx from the Power Expander and plugged in the JR switch like the manual shows. Then I plugged the rx back into the power expander and all is working fine and the failsafe is set.