FlyingGiants - View Single Post

shannah · 01-29-2007, 10:38 AM

The 1/2"-1" gap is there to make sure you don't get any contact between the pipe and header. If they touch, the metal on metal grinding creates a lot of RF noise. Whatever you end up with, the total length is 10.75"

People are running the Mejzlik 32x10 two blade and the Mejzlik 28.5x12 with this header length.

01-29-2007, 10:38 AM	#3
shannah Bad-ass Super Contributer! Join Date: Jan 2006 Location: Orange County CA Posts: 233	Re: DA150 and Greaves Tune Pipes The 1/2"-1" gap is there to make sure you don't get any contact between the pipe and header. If they touch, the metal on metal grinding creates a lot of RF noise. Whatever you end up with, the total length is 10.75" People are running the Mejzlik 32x10 two blade and the Mejzlik 28.5x12 with this header length.