Craig, It's not as simple as you imagine. The DX7 assigns a switch to each
programmable mix. The switch has to be disabled in order to avoid accidental
reversing of one control surface while flying. This isn't mentioned in the book
or in your post so you may not be aware of it.
Ken
|
|
|
|
|
|
|
heya trike.....
ive been looking at the manual for the spektrum dx7 here. i found that on page 56 it mentions about using 2 servos on 2 channels. its in the programable mixing 1-6.
if you use mix number 5 or 6 you will have a "dual servo trim function" where a primary control surface trim will control the slave servo.
i have used this programming myself on my JR 9XII radio...its the same as the dx7 (the dx7 programming is the same as JR anyways)
thought this may help
cheers
craig |
|
|
|
|