Well you know what they say about best laid plans... I planned to use my print out and simply cut and paste. When I put the print next to my plane and the bright orange, I couldn't deal with the color differences. BUT, not all is lost. I simply cut out the letters with a sharp razor and decided to do a quick paint mask stencil. Once I got the 'Yak' cut out I sprayed a light mist of 3M77 spray glue on the back to provide some tackiness to the stencil. I positioned it where I wanted it and smoothed it down. I couldn't forget about the center from the 'A' so that was stuck down too. I used the cut out 'A' to locate it.
Man, I can't wait to get a motor and servos for this thing and go flying!!
