FlyingGiants - View Single Post

Toro · 08-23-2007, 01:21 PM

If your running align 600A carbon mains, you need to consider to stop using them ASAP. There has been a few cases of the lead weights being slung out of the tip at bullet speed in one case striking an individual causing a maming injury. He has lost one of his fingers. If your using them take this as a warning. Using them could cause the loss of heli, and perhaps a severe injury.

ALIGN Is an OUTSTANDING company, and is already investigating this. I know that in the end they will definately make right...

This statement is an FYI, and is not going to turn into a slam thread !

This only applies to the "A" blades or the carbon fiber 600MM part # H60115.

That is all

08-23-2007, 01:21 PM	#1
Toro Bad-ass Super Contributer! Join Date: Jan 2006 Age: 39 Posts: 2,340 Awards Showcase Total Awards: 1	TREX 600 FLYERS LOOK HERE ASAP ! If your running align 600A carbon mains, you need to consider to stop using them ASAP. There has been a few cases of the lead weights being slung out of the tip at bullet speed in one case striking an individual causing a maming injury. He has lost one of his fingers. If your using them take this as a warning. Using them could cause the loss of heli, and perhaps a severe injury. ALIGN Is an OUTSTANDING company, and is already investigating this. I know that in the end they will definately make right... This statement is an FYI, and is not going to turn into a slam thread ! This only applies to the "A" blades or the carbon fiber 600MM part # H60115. That is all