[OnTheEdge]

Coming along nicely Gareth! Look forward to seeing your progress. Are you planning on using weights to skin the foam pieces or vacuum bagging?

Also, just as an fyi....Dennis marks all the foam outer shuck bottoms so you know which one if the "true" base shuck. This is the side that goes down on the board to make sure everything stays straight and true while gluing on the skins. The first thing I do is mark all the root and tips of the foam parts so you know which shucks go with which cores. When you do this, scribe a line or two staight across the cut line. This will allow you to line up the shucks/cores when you glue on the sheeting.

Dennis is a wealth of info and one of the best at describing something over the phone. If you run into a jam, give him a call.

Also ask questions here, there are lots of guys here to help.

Have fun...........