FlyingGiants - View Single Post

Jaketab · 11-10-2007, 12:59 AM

Thanks Neil,

The problem I'm having with the 30% Yak, is the suggested location for the servo mount tray is too high for proper cable alignment. If I put the tray where recommended, the cables would exit and extend below the rudder.

I don't like crossing cables, but looks as if no other choice.

Another obstacle is drilling the hole in the rudder for the control horn rod. Because of the bevel in the rudder, it is difficult to align the rod straight. Any short cuts you know of?

I almost got the 33% SD Yak for my DA-85, but the AW Extra was available first so I went with that. Turned out to be a great match.

Jaketab

11-10-2007, 12:59 AM	#3
Jaketab Super Contributer Join Date: Aug 2007 Location: Charleston, WV Posts: 106	Re: SD Models 30% Yak Build Questions Thanks Neil, The problem I'm having with the 30% Yak, is the suggested location for the servo mount tray is too high for proper cable alignment. If I put the tray where recommended, the cables would exit and extend below the rudder. I don't like crossing cables, but looks as if no other choice. Another obstacle is drilling the hole in the rudder for the control horn rod. Because of the bevel in the rudder, it is difficult to align the rod straight. Any short cuts you know of? I almost got the 33% SD Yak for my DA-85, but the AW Extra was available first so I went with that. Turned out to be a great match. Jaketab