FlyingGiants - View Single Post

gareth.ky · 11-21-2007, 10:07 AM

Gotcha.

One thing I noticed is in some places the seams are still a bit rough after sanding with the 150 grit. Mostly where the seam is lower than the surrounding wood. I figured it would be easier to get to the seams after the skin was curved over the foam. I was concerned about how much material I was going to sand through to get to those areas on a flat surface. Still I would just have to touch those areas up afterwards and not do the whole thing.

11-21-2007, 10:07 AM	#26
gareth.ky Caymanian Pirate Code Monkey Join Date: Jul 2006 Location: Mustang OK, USA Age: 31 Posts: 1,929	Re: n00bs Gonna Build a Carden Gotcha. One thing I noticed is in some places the seams are still a bit rough after sanding with the 150 grit. Mostly where the seam is lower than the surrounding wood. I figured it would be easier to get to the seams after the skin was curved over the foam. I was concerned about how much material I was going to sand through to get to those areas on a flat surface. Still I would just have to touch those areas up afterwards and not do the whole thing.