[vsnap]

Cowl Tips:
This cowl is very tight on the mounts. Becareful the first couple of times untill it stretches some, and it will. I suggest leaving it on as much as possible while working on wings and tail surface. When mounting it should slide back to cover the wood bulkhead in front of the canopy hatch.
When marking screw holes I found a small bendable flashlight (will post pics) on a dowel to work great.
1: make sure blind nuts are free of balsa dust.
2: tape light to a dowel and bend tip 90 degrees
3 place dowl with light into cowl on up into the cowl mount from behind. The light will shine through the cowl for marking. Make sure it is 90 degrees when in the cowl up behind the blind nut.

Also the 6 black silicon rings in a rectangle mat are for the cowl mount screws. Just push the 3mm screw through the hole and the grommet will pop out. The small step insets into the cowl for a cushion to protect the cowl from vibration.

Scott