While I was busy putting the Rudder rack together, Ron mounted the engine and assembled the fuel tank.
There is a template provided with the instructions that is simply lined up with the cross hairs already on the firewall and then the four holes are marked and drilled. Turns out, these holes are PERFECT!!! So, after you drill the holes, install the T-Nuts and bolt the motor right up with the supplied standoffs.
It saves SOOOO much time to just have this part already science'd out!
Once the motor is mounted, place the ignition module underneath the engine box with Zip-Ties or the included velcro straps. Included with the kit are a bunch of "U" shaped clamps for securing the ignition wires. I secured my lines with Zip-Ties and fuel tubing for anti-chaff,, the provided clamps make for a very tidy installation though.