They're even wiping out on water now...
|
|
|
|
|
|
I am a racing boat modeller from Germany and using the IFS Graupner System with MX-22 with XR-16 IFS receiver since March 2008. During the last championship race (April 2008) my system go into fail safe but the 1 second minimum possible fail safe time was to long to prevent a full speed crash with the quay wall. My request to Graupner was to minimize the possible fail safe time to JR "standard" 0,25 sec or less. Is there any update available to have this possibility in the "near" future. I change the system back to 40Mhz SPCM because I run my boats during approx. 20 years without any big "impact" like the above described. Fore sure, the problem which caused fail safe, I have also to investigate, but due to the speed of our boats, approx. 80km/h, 1 second fail safe response time is still to long and means approx. 25m movement without control before throttle goes to idle. Any update from JimDrew will be appreciated.
Regards Stefan |
|
|
|
|
http://www.rcgroups.com/forums/showthread.php?t=871567