[gazzajp]

Hello everyone, new member here and this is my first post. Anyway I recently got me a gf26I and have a little problem with it. On the first startup, the thing vibrated badly. I found that the output shaft was out of true by a long way. I removed it and found that it was a little loose and the spring washer behind it was making it run out. The thread relationship between it and the crank is sloppy as. So I put it back on without spring washer and done it up tighter. It now runs as close to true as I can get it - probably about .2mm out. The only thing I noticed later is I may have to much pressure on the prop hub. It has a slight crack in it maybe caused by the taper spreading it out? Just wondering if anyone else has had this drama. I read in previous posts about key and hub issues, but the hub is spot on. The only thing is I may need a new one now. Was also considering getting a new output shaft made up. In doing this I hope that it screws onto the crank thread without so much slop