FlyingGiants - View Single Post

mogley · 07-21-2008, 04:38 PM

did some more tuning on the g62, high end is still at 3/4 and a tad more open. Here I get max rpm of 6300 turning a zinger 22x10. Where can I buy a needle setting gauge? Low end is now set a littler leaner and I'm also getting a good transition. It just loads up a bit when idling for a bit and I have to add throttle slowly. After it is spooled up once, acceleration is perfect again. It will also hold the peak rpm. I was hoping for higher rpms. Will a Mezlik 24x10 be too much (this is the next prop I want to try)?

07-21-2008, 04:38 PM	#231
mogley Flyin' Around Join Date: Aug 2006 Location: naples,fl,usa Posts: 14	Re: Gas engine tuning for newbies.... did some more tuning on the g62, high end is still at 3/4 and a tad more open. Here I get max rpm of 6300 turning a zinger 22x10. Where can I buy a needle setting gauge? Low end is now set a littler leaner and I'm also getting a good transition. It just loads up a bit when idling for a bit and I have to add throttle slowly. After it is spooled up once, acceleration is perfect again. It will also hold the peak rpm. I was hoping for higher rpms. Will a Mezlik 24x10 be too much (this is the next prop I want to try)?