FlyingGiants - View Single Post

Smacka · 12-21-2008, 08:13 PM

Hi All:
I have opted to use a single 400 oz rudder servo, instead of two 180 oz servos. That said, the manual recommends a straight 3 1/2-inch full rudder servo arm. I was on SWB's website and they only advertize a 3-inch straight full servo arm. The only other arm close is their 3 1/2-inch full offset servo arm, which is designed to use with rudder cables that cross in the fuselage.

Can this offset arm be used for my application, even though I do not plan to cross the cables?

Thank you!

12-21-2008, 08:13 PM	#1
Smacka Bad-ass Super Contributer! Join Date: Jun 2008 Location: Weedville, PA Posts: 2,125	Aeroworks 85cc Yak 54 Rudder Linkage Hi All: I have opted to use a single 400 oz rudder servo, instead of two 180 oz servos. That said, the manual recommends a straight 3 1/2-inch full rudder servo arm. I was on SWB's website and they only advertize a 3-inch straight full servo arm. The only other arm close is their 3 1/2-inch full offset servo arm, which is designed to use with rudder cables that cross in the fuselage. Can this offset arm be used for my application, even though I do not plan to cross the cables? Thank you! __________________ There is a very fine line between complaining about whiny little beyotchs, and "being" a whiny little beyotch