FlyingGiants - View Single Post

Sevans16 · 12-21-2008, 11:11 PM

Check out my thread on here in the GS Git R Done section.

I used a Greeves pipe, pull-pull setup and it is balancing at 4" back, 1/2" past the 3.5" mark called for. I also set mine up with the 1 1/4" full arm. The 1.5"(3") arm would be plenty I think??

12-21-2008, 11:11 PM	#3
Sevans16 Bad-ass Super Contributer! Join Date: Jan 2007 Location: Sin City Age: 36 Posts: 515	Re: Aeroworks 85cc Yak 54 Rudder Linkage Check out my thread on here in the GS Git R Done section. I used a Greeves pipe, pull-pull setup and it is balancing at 4" back, 1/2" past the 3.5" mark called for. I also set mine up with the 1 1/4" full arm. The 1.5"(3") arm would be plenty I think??