FlyingGiants - View Single Post - Smart-Fly Setup Help

almmendes · 01-06-2009, 02:31 PM

I have never worked with any smart-fly devices and therefore do not have any experience in this subject and that is why I'm asking for directions in what to do.

As you can see in the pictures I have the Futaba Power Expander Model 4804, the TurboReg and the flag switch. I know I'm missing the ignition cut-off but I don't have a clue how to assemble this and what to expect. I didn't yet bought any batteries as well... I'm thinking Li-Po for the RX because I don't have a A123 charger and a Ni-Mh for the ignition.

I want to get this setup in my 3DHS 50cc Katana, with a DL-50 and HS-625MG (elevator and rudder) and Maxx MS-870MG in the ailerons. I'm going to use my Futaba 9CAPS on 72MHZ and a PPM RX.

What ignition cut-off should I get? What batteries should I get? How do I connect all this?

Thanks

01-06-2009, 02:31 PM	#1
almmendes Antonio Mendes Join Date: May 2006 Location: Longmont, CO Age: 32 Posts: 890	Smart-Fly Setup Help I have never worked with any smart-fly devices and therefore do not have any experience in this subject and that is why I'm asking for directions in what to do. As you can see in the pictures I have the Futaba Power Expander Model 4804, the TurboReg and the flag switch. I know I'm missing the ignition cut-off but I don't have a clue how to assemble this and what to expect. I didn't yet bought any batteries as well... I'm thinking Li-Po for the RX because I don't have a A123 charger and a Ni-Mh for the ignition. I want to get this setup in my 3DHS 50cc Katana, with a DL-50 and HS-625MG (elevator and rudder) and Maxx MS-870MG in the ailerons. I'm going to use my Futaba 9CAPS on 72MHZ and a PPM RX. What ignition cut-off should I get? What batteries should I get? How do I connect all this? Thanks Attached Thumbnails 96.7 KB · Views: 47 112.1 KB · Views: 43 105.7 KB · Views: 32 __________________ Antonio Mendes http://www.milehighrc.com/