the landing gear goes on easy. inside the fuse there are 2 alu brackets that hold the gear plate inplace.
the tailgear ( also CF) went on by marking and drilling 3 holes on the tail and inserting blind nuts through the little hatch on the side of the fuse at the back.
I don't know about other planes but the rudder delfection (to me) is going to be crazy in the air lol.
The rudder control horn needed a bit of sanding to get it to fit snug and correctly.
the pull pull is also preinstalled!
the elevator servos just fall into place with ease.
also added some photos of her on her feet