FlyingGiants - View Single Post

Danny Baker · 01-17-2009, 02:26 PM

Should be fine with 1.25 on Airlerons, 1.5 on elevator, and 3" on rudder. Use offset if your wires cross, use straight if your wires (pull pull wires) are straight. If you find that the outer hole in these arms are too much throw, dont dail down the % in the transmitter, move the pushrod in one hole CLOSER to the servo, it saves on servo gear wear.

01-17-2009, 02:26 PM	#2
Danny Baker Uber Contributer Join Date: Nov 2008 Posts: 197	Re: SWB servo arms Aeroworks extra 260 50cc Should be fine with 1.25 on Airlerons, 1.5 on elevator, and 3" on rudder. Use offset if your wires cross, use straight if your wires (pull pull wires) are straight. If you find that the outer hole in these arms are too much throw, dont dail down the % in the transmitter, move the pushrod in one hole CLOSER to the servo, it saves on servo gear wear.