FlyingGiants - View Single Post

Spooky · 02-06-2009, 05:41 PM

Sounds like your making new parts from the Part file (wing) and not in an assembly... If the wing is a component of an assembly, you insert a new part into that assembly, make your sketch plane in the new part of the assembly and do the intersect curve sketch with that.

I hope that makes sense.

02-06-2009, 05:41 PM	#25
Spooky Wood Splitter Join Date: Dec 2008 Posts: 245	Re: SolidWorks & wings Sounds like your making new parts from the Part file (wing) and not in an assembly... If the wing is a component of an assembly, you insert a new part into that assembly, make your sketch plane in the new part of the assembly and do the intersect curve sketch with that. I hope that makes sense.