FlyingGiants - View Single Post

HugoW · 03-24-2009, 05:27 PM

Tonight I did a little 'engineering' on the airleron servo idea:

The servo hole is already in the rib, the rest of the drawing is schematic but accurate. As you can see, this movement would allow for an up-swing of 63 degrees, and down-swing of 40 degrees. Servo arm is 25mm (about an inch) and so is the distance from the hing point to the linkage. With a little end-point setting on the TX or with digital servos, I'd be in business, right?

Cheers,

Hugo

03-24-2009, 05:27 PM	#7
HugoW Flyin' Around Join Date: Mar 2009 Posts: 27	Re: EMHW 2m Funtana, but not really... Tonight I did a little 'engineering' on the airleron servo idea: The servo hole is already in the rib, the rest of the drawing is schematic but accurate. As you can see, this movement would allow for an up-swing of 63 degrees, and down-swing of 40 degrees. Servo arm is 25mm (about an inch) and so is the distance from the hing point to the linkage. With a little end-point setting on the TX or with digital servos, I'd be in business, right? Cheers, Hugo