|
|
|
|
|
|
|
I just tried this, and amazingly my simplest mind figured most of it out. now could you explain how you go about making the cuts in the wing ribs on the underside of the "loft" / wing skin. I tried to use an extrusion cut, but it went from the center line of the end planes. |
|
|
|
|
Wasn't thinking when I answered your question, so I edited the above post to make it clearer, swept-cut should have been loft-cut, my bad
. And when I looked back at how I did it, I used one sketch and swept-cut that using the wing-loft guide curve for the LE & TE swept-cut guide curve too.
Dean