FlyingGiants - View Single Post

esc · 06-30-2009, 05:08 AM

Hey, Wojcigitty - you are more than welcome, credit where it's due.

Re: the wing tips - Blast! - I did an Autodesk training course yesterday on advanced surfacing and was looking forward to putting my newly gained knowledge into some fancy wing tips :-(

Certainly the way the tips are drawn is the simplest easiest to achieve an end result which may in the long run prove to be the most efficacious solution.

I will finish the drawings off and then it's over to Mr. Guinea Pig himself (rcpilot82) to tell us all the results - no pressure! :-)

Dave

06-30-2009, 05:08 AM	#39
esc Uber Contributer Join Date: Jun 2008 Posts: 164	Re: What software are you guy's using? Hey, Wojcigitty - you are more than welcome, credit where it's due. Re: the wing tips - Blast! - I did an Autodesk training course yesterday on advanced surfacing and was looking forward to putting my newly gained knowledge into some fancy wing tips :-( Certainly the way the tips are drawn is the simplest easiest to achieve an end result which may in the long run prove to be the most efficacious solution. I will finish the drawings off and then it's over to Mr. Guinea Pig himself (rcpilot82) to tell us all the results - no pressure! :-) Dave Last edited by esc; 07-01-2009 at 11:18 AM.