FlyingGiants - View Single Post

esc · 07-08-2009, 01:40 PM

Rob, that's good.

"Rampage" or how about "R-Ampage" goes to number 1.

Anyone care to offer another name?

Do you think anyone would kind enough on this CAD/CNC web site to cut us a vynil logo for Rob's plane?

BTW I had just made up my mind to buy "CompuFoil3D" when I discovered it was sold in modular form. So to get the modules I wanted it was going to cost $120 instead of the $38 I originally thought. Since I will not be using the software enough to warrant that expense I went back to reconsidering "Profili."

I have just sent the programmer an email and if the answer I receive in return is satisfactory I will go with "Profili" instead. Getting a nice smooth DXF file of the aerofoils I want to use is all that is holding back progress on the new design.

Dave

07-08-2009, 01:40 PM	#86
esc Uber Contributer Join Date: Jun 2008 Posts: 164	Re: What software are you guy's using? Rob, that's good. "Rampage" or how about "R-Ampage" goes to number 1. Anyone care to offer another name? Do you think anyone would kind enough on this CAD/CNC web site to cut us a vynil logo for Rob's plane? BTW I had just made up my mind to buy "CompuFoil3D" when I discovered it was sold in modular form. So to get the modules I wanted it was going to cost $120 instead of the $38 I originally thought. Since I will not be using the software enough to warrant that expense I went back to reconsidering "Profili." I have just sent the programmer an email and if the answer I receive in return is satisfactory I will go with "Profili" instead. Getting a nice smooth DXF file of the aerofoils I want to use is all that is holding back progress on the new design. Dave Last edited by esc; 07-08-2009 at 01:51 PM.