[esc]

Rob, me offended - no way!

I had a similar conversation with Spooky not too long ago and I told him that I am a Yorkshireman, we are straight talkers and appreciate the same in return.

You just keep on as you are and we will get along fine.

Re the logo - if you can find someone to cut it I will send you an AutoCAD drawing or DXF file as the attached image is very poor quality. BTW just because I have posted a logo don't think you are obliged to use it - you may hate it for all I know?

I was just thinking about the short grained sections again - you could apply some thin cyano that would add a lot of strength without adding much weight. That also reminds me of something I meant to mention - hardening mounting holes (servos, motor and hatch) with cyano.

Regards,

Dave